Technical Features - GIRBAU FL Series Technical Manual

1.5 TECHNICAL FEATURES

The technical features of the FL SERIES vary depending on the options ordered.
Several folds can be made, depending on the model:
1, 2, or 3 primary folds in 1, 2 or 4 lanes using an air jet (the item comes out with
the corners inside),
1, 2, or 3 primary folds in 1 to 2 lanes using mechanical blade (the item comes out with
the corners inside).
The items are measured on the folding machine feeder conveyor:
- A roller in contact with the linen turns and drives an optical pulse generator (OPG),
- A cell triggers the start and end of impulse counting.
This makes this measurement regardless of the speed of the ironer, allowing very accurate
folding
Options:
- Feeder with by-pass 1V2V
- Antistatic double bar
- Front end remote control
- Small linen receiver
- Dirty/Torn selection using flap or bell and warning light
TECHNICAL
FEATURES
Power installed
Power cable section
Basic voltage and frequency
Maximum supply pressure
Power cable section
Maximum supply pressure
Power consumption
for 100 items
Air pressure safety switch
Noise level
Height
Mass
Weight/Foot (Pressure on the ground)
Lu = 3000
Lu = 3300
Lu = 3500
Humidity
Primary
Cross
13
FL-SMART
ELECTRICAL
3 to 4,5 KVA
380-400 Volts/50 Hertz
COMPRESSED AIR
Ø15 x 21
6 bars with temporary pressure drop
de 0,5 bars maximum
5 Nm³/100p
835l/100p at 6 bars
Set to 4.8 bars
OTHERS
1840 + 80 lifting rings
1 800 to 2 300 kg
57 to 73 N/cm² / 4 feed
Useful Width (Lu)
4010 mm
4010 mm
4010 mm
Operating temperature
5°C to 40°C
95% at 25°C without condensation
Conveyor speed
10 to 50m/min
65m/min
FL-KING
3x2.5²
10 bars
76 dbA
FL0610A