Setting the colour of the
display illumination
You can adjust the colour of the display
illumination to suit the illumination of
your vehicle cockpit. The primary col-
ours red, green and blue (R-G-B) are
available for this.
Setting a colour for the display
illumination
➮
Press the MENU button 7.
➮
Press the
or
edly until "DISP COL" appears in
the display.
➮
Press the
or
The menu for adjusting the colours is
displayed. "R", "G" and "B" are displayed
with the current values. The "R" setting
flashes.
➮
Press the
or
edly until the setting that you want
is displayed after "R".
➮
Press the
or
move the selection cursor to the
position after the other colours ("G"
or "B").
➮
Adjust the other colours to suit your
preferences.
When you have finished adjusting the
setting,
➮
Press the MENU button 7 twice.
The settings are saved.
button 6 repeat-
button 6.
button 6 repeat-
button 6 to
DISPLAY ILLUMINATION
Selecting a display illumination
colour during a scan
You can select the colour of the display
illumination during a "scan". During the
scan, the display shows all the possible
colour variations that are available in the
RGB spectrum. The scan takes approx.
40 seconds.
➮
Press the MENU button 7.
➮
Press the
or
repeatedly until "COL SCAN"
appears in the display.
➮
Press the
or
The colour scan begins. All the possi-
ble colour variations that are available
in the RGB spectrum are shown in the
display one after another.
If you want to select the display illumi-
nation colour that is currently being
shown,
➮
press the MENU button 7.
The settings are saved.
If you want to cancel the scan without
setting a new colour,
➮
press the
or
Note:
If you do not press a button, the
●
scan will stop after cycling through
the colours once (approx. 40 sec-
onds) and the previously selected
colour will be applied as the setting
again.
button 6
button 6.
button 6.
63