Basic Settings Tab - Multicast (Slave Settings) - Algo 8190S User Manual

Basic Settings Tab – Multicast (Slave Settings)
Multicast Mode (Slave Selected)
If Slave is enabled the 8190S will activate when receiving a multicast message. It will
mimic the audio stream, but use local volume settings ('Page Speaker Volume' in Basic
Settings > Features).
Number of Zones
Select 'basic' zones if configuring nine or fewer multicast zones or 'expanded' to configure
up to 50 zones. The expanded zones have the same behavior as the basic Slave zones,
but are hidden by default to simplify the interface.
Multicast Type - Regular
Select 'Regular (RTP)' if solely multicasting to Algo SIP endpoint(s) and/or multicast
enabled phone(s) that use RTP audio packets.
Multicast Type – Polycom Group Paging/Push-to-Talk
The 8190S may receive multicast paging compatible with Polycom "on premise group
paging" protocol.
To configure the 8190S as a slave to play Polycom page announcements, select "Group
Page" or "Push-to-Talk". Then enter the Polycom Zone (IP Address and Port) that
matches the configuration of the Polycom phones and Channels. The "Default Channel" is
the target group in a Polycom paging environment.
The Polycom phone used as a page audio source for the 8190S SIP Classroom
Speaker(s), must be configured to use either the G.711 or G.722 audio codec. The
Document 90-00105
03/09/2020
Page 25
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8190S SIP Classroom Speaker with Strobe FW 3.1
support@algosolutions.com
(604) 454-3792