Setting The Gas Grill - Siemens HG2L10B50M Instruction Manual

Operating the appliance
en

Setting the gas grill

Open the top cover. The top cover must remain
1.
open for as long as the appliance is in operation.
Turn on the main gas supply to the appliance. Insert
2.
the plug into the socket.
Insert the protecting plate into the groove below the
3.
control panel.
Insert the protecting plate with the longer edge at the
front and the curvature at the bottom.
Secure the protecting plate in the groove below the
control panel using the retainers.
Ensure that the protecting plate is engaged in the
retainers. If the protecting plate cannot be removed,
it is properly engaged. You can now safely use the
protecting plate. If it can be removed, insert it into
the groove at a slightly higher angle and make sure
that it engages in the retainers.
Close the oven door so that it is as close as possible
4.
to the protecting place.
Push in the function selector and turn it clockwise to
5.
the grill setting .
(
Keep the function selector pressed in and press the
6.
ignition button 8 at the same time.
The gas coming from the gas grill is ignited using
7.
the ignition button. Keep the function selector
pushed in for 10 seconds so that the safety pilot
starts up.
The safety pilot is activated. If the gas flame goes
out, the gas supply is automatically shut off by the
safety pilot.
Check whether the flame continues to light up. If the
8.
flame goes out, repeat the process from step 5.
Once the food is cooked, switch off the function
9.
selector. Once the oven has cooled down, remove
the protecting plate.
:
Warning – Caution!
Do not actuate the selector for longer than 15 seconds.
If the burner does not ignite within 15 seconds, wait at
least one minute. Then repeat the ignition process.
20
Caution!
The gas grill only works when the protecting plate is
inserted.
Make sure that the protecting plate is correctly inserted.