How To Use Auto Self-Test - Alps Electric FlexPitch Operator's Manual

Leak tester

Hide thumbs Also See for FlexPitch:

Table of Contents

AIR LOGIC POWER SYSTEMS (ALPS)

Follow the Steps below:

FLEXPITCH  ADVANCED OPERATOR MANUAL

How to Use Auto Self-Test

1. Select Auto Self-Test ON/OFF:

2. Select Alarm Mode

3. Select Self-Test interval

4. Counts to (go) to Auto Self Test

5. Warning has occurred indicating which head

PASSED a bottle.

6. PASSED, means a leak was integrated into

the bottle but it PASSED anyway. The

bottle should have FAILED and been

rejected.

7. The Warning must be re-set before it can be

cleared

8. Alarm must be re-set before machine can

run. Same as above except Alarm Mode will

stop machine.

a. Turns yellow and indicates ON

b. Turns gray and indicated OFF

a. Warning machine will run on PASS

b. Alarm machine will stop on PASS

a. Number of containers per Self-Test

a. A warning or an alarm may be an

indication of a problem

i. Check test settings

ii. Check station probe alignment

iii. Check correct orifice is

installed

MAINTENANCE MENU

Table of Contents

Do you have a question about the FlexPitch and is the answer not in the manual?