Advertisement
Console User Guide
ZR14 Treadmill
Quick Speed
Used to select an exact speed whilst running
Quick Incline
Used to select an exact incline whilst running
Quick HRC
Used to select an exact HRC program, HRC1, HRC2 or HRC3
Quick User program
Used to select an exact user program, U01, U02, U03
MP3 Input
Allows connection to personal MP3 player via supplied cable. Music will be played through built in speakers
and volume controlled by MP3 player.
Fan
To turn Fan on or off
Safety Key
Included with this machine is a red Safety Key, without which the treadmill can't operate. Its purpose is to
immediately stop the machine in the event of an emergency. "---" will be displayed immediately and a beep
sound will be heard, if the key is not correctly attached to the treadmill. Two or three seconds later computer
will display"PLEASE INSTALL SAFE KEY" until the key is in place. The clip on the other end of the safety key
must be attached to the user at all times during your workout to ensure the machine stops immediately in
the event of an emergency.
HANDLEBAR CONTROLS
Speed +/-
Located on the handlebar the SPEED + or – buttons can be pressed to change the running speed at any
time during a program.
Incline p/q
p/q
Located on the handlebar the INCLINE
buttons can be pressed to change the incline level of the
running deck at any time during a program.
Pulse grips
There are pulse sensors located on the handlebars. In order to monitor the users pulse rate these can be
held during workout. Please note both sensors must be held in order for the reading to be given. The
pulse monitor is a guide for reference only and not for medical use or monitoring.
04
COMPUTER PROGRAMS
P0 - Manual Program (Normal mode, Time, Distance and Calories countdown mode)
P01-P24 - Preset workout programs
FAT - Body Fat program
HRC1-HRC3 - Heart Rate Control programs
U01 – U03 - User defined programs
P0 Manual Program
1. From Standby press START to begin normal manual mode immediately.
2. The TIME/DISTANCE/CALORIES will count up from zero.
3. Treadmill speed can be manually adjusted by using the Speed + or – buttons at any time
during a workout.
Time, Distance and Calories countdown mode
1. From standby press MODE to select time, Distance and Calories countdown mode.
2. Once selected use INCLINE +/- to alter the required setting and press START to begin.
3. The TIME, DISTANCE or CALORIES will count down from the selection
4. Once the countdown has completed the computer will show "End" and beep to indicate the end of the
program and all readings will be reset to zero.
P01-P24 Programs
These are preset programs in which the machines speed or incline will be changed automatically during
a workout.
Note: If speed/incline is altered by the user during these programs it will revert back to the preset speed/
incline at the next segment of the program.
1. From standby screen, press program button to select required program.
2. The default workout time for these programs is 30 minutes. This can be altered by pressing incline +/-
buttons before START is selected.
3. During these programs the speed and incline settings are split into 20 segments. The time of each
segment depends on the overall time selected. For example a 20 minute program = 20 segments of 1
minute. Therefore the speed/incline would alter approximately every 1 minute. Times will differ to allow for
warm up and cool down.
4. Press START to select and begin using the preset time
5. The console will show" End" and beep every second until the running belt stops when the preset time
reaches zero
05
reebokfitnessequipment.com
Advertisement
