Steam Function; Detergent Tank; Switching On; Function Programming - Kruger KGV8000 Instruction Manual

threaded holes, by means of two M4 lobe-knobs, always placed in the accessory box, with the aid
of the L key. (Fig. 18).
Fig. 18

3.2 STEAM FUNCTION

Unscrew the tank cap (10) (Fig. 1.2) and fill it exclusively with drink water. It's strictly forbidden to
fill the boiler's water tank with detergents, perfumes or other chemicals.
All water entering the machine is filtered by a meshed filter and then by a patented
magnetic technology that allows limestone to break the bonds between the molecules that cause
the creation of limestone, in this way, although it is not possible to stop limestone creation,
you can limit it. (It is important to remember that this device does not replace the obligation to
provide frequent maintenance, like boiler draining or the use of anti-limestone product
recommended by Krüger Technology that prevents damage caused by the limestone).
Caution: It is absolutely compulsory to add to the water tank, both water and hydrojet,
the anti-limestone product recommended by the manufacturer. The amount to be added for
each liter of water is 2.5 grams, the lack or use of the wrong amount of anti-limestone
causes serious problems that damage the major organs of the cleaner. The manufacturer
grants no warranty for problems resulting from failure / misuse of the product, the use of
a different product and in general from damage caused by limestone.
3.3 DETERGENT TANK
Unscrew the tank cap (8) and pour detergent thinned with water.
WARNING: Use only the detergent recommended by the manufacturer. It's strictly forbidden to
pour foaming detergents in the tank, or detergents which may develop toxic gases or irritating
substances when they come into contact with heat. If incompatible products are used, the
cleaner may be subject to irreparable damage.

3.4 SWITCHING ON

Plug the power supply cable into a suitable socket, as stated on the technical specifications label.
Push the lower part of the main switch (11) (Fig.2). The green light on the switch will illuminate.
3.5 FUNCTIONS PROGRAMMING
By operating the control handle, both the amount of steam to be released and the vacuum power
can be programmed. The device is supplied with electronic circuits which allow to optimize the
performance, inline with the specific needs of the user.
7