Steam And Detergent Cleaning; Steam And Hydrojet Cleaning - Kruger KGV8000 Instruction Manual

goes under the minimum, the "LACK OF WATER/HYDROJET" alarm activates.
When the alarm is on, the machine stops delivering steam (if the detergent/hydrojet function is on,
the machine stops this function too). In order to get back to the normal functioning switch the
machine off, unscrew the water tank cap, remove the tank and fill it with water. Now, switch the
machine on again and go on working.

6. STEAM AND DETERGENT CLEANING

It allows the mixing of steam with a special detergent which increases the cleaning power, this
function is achieved by means of a vibration pump, fishing detergent from the tank and mixes
intermittently detergent with steam through a metal union.
When the detergent is missing, a LED alarm activates.The LED light (A, Fig. 3) turns on and a beep
duration of 5 seconds activates, after which it will remain only the intermittent LED to remind us
that the detergent is finished, without disturbing the user with the continuous repetition of sound. It
is possible to continue to work with only hydrojet. The water is caught and mixed with steam and
supplied from the hose. Following lack of detergent alarm it is necessary to fill the tank and at the
end of the acoustic signal, turn on the detergent function. The control of detergent function is made
by the rotation of the ring on the handle of the gun, to position "4", while the delivery is made by
pressing the trigger placed under the grip. The switch located in the front of the machine must be
placed, instead, on position "I". Otherwise hydrojet function will be activated.
This function does not allow the possibility of adjustment.
Caution: it is essential to use only Detergents approved by the manufacturer, the use of
detergents that are not approved / tested can cause damage to the machine and people to
whom the manufacturer does not may be responsible.
7. STEAM AND IDROJECT CLEANING
Allows mixing steam with a specific jet of boiling water, which helps to wash out accumulated dirt
surfaces. Hydrojet function is realized through the actuation of a third pump that takes water from
a tank with a capacity of 5 liters (the same from which water is drawn for the production of steam).
The lack of water inside the tank causes an alarm that activates a LED signal and an acoustic signal
lasting five seconds, after which it will remain only the flashing LED to remember that the water in
the tank is finished, not disturbing the user with the continuous repetition of the sound. In absence
of liquid in the water tank you can' t keep working because all functions are suspended. To restore
normal operation it is necessary to reset the alarm. To do this: switch off the device, fill the water
tank and restart the machine. The drawn water is filtered by a patented anti-limestone filter using
magnetic technology, then mixed with steam and delivered from the steam hose.
The control of hot water injection function is realized through the rotation of the ring on the handle of
the gun, to position "4", while the delivery takes place with the pressure of the trigger placed under
the grip. The switch located in the front of the machine must be placed on position "II". Otherwise
detergent function will be activated. Hydrojet function can be selected in any condition and will
activate steam at the second speed. This function does not allow the possibility of adjustment.
Caution: it is always essential to put the anti-limestone product into the tank water, otherwise
in a short time the pipes will be filled with limestone and the machine will fail quickly. The
manufacturer grants no warranty for problems resulting from failure / misuse of the
anti-limestone product, the use of a different product from Krüger Technology anti-limestone
and in general from damages caused by limestone.
9