Safety Warnings - Kruger KGV8000 Instruction Manual

1. SAFETY WARNINGS

• Before using the appliance for the first time CAREFULLY READ the operating instructions.
• Before plugging in the device, make sure that the supply voltage corresponds to that indicated on
the specifications of the device and that the electrical outlet is grounded and has protection differential.
• Do not disconnect the plug by pulling the power cord. Keep the power cord away fromheat, steam
and oil.
• Do not touch the device with wet hands or feet when plugged in.
• Never leave the device unattended when plugged in. Unplug the device when not in use.
• Before cleaning ovens, refrigerators, lamps,etc., unplug the appliances.
• Do not immerse the device into water or other liquids.
• The device is not to be used by children or persons who do not know how to operate it.
• Use the unit only on flat surfaces.
• Never fill the boiler's water tank with detergents, perfumes or other chemicals. Risk of fire/explosion.
• Only use drink water, and never distilled water.
• Keep away from the steam release. Danger of scalding!
• Never point direct steam in the direction of people or animals. Danger of scalding!
• Never point direct steam in the direction of electrical appliances.
• Do not put any stress on the hoses or the accessories while in use. It's useless and harmful. The
cleaning efficiency is generated by the steam or the vacuum power, or by the combination of steam
and detergent. The appliance can be implemented in a number of ways, also thanks to the variety
of steam delivery settings.
• Steam should not be applied (or should be used with great care) in the following cases:
-items or pieces of furniture covered in leather, synthetic velvet or very delicate fabric;
-waxed or painted floors as steam can remove wax or paint;
-silk printed or painted glass;
-polished wooden surfaces;
-in direct contact with glue or silicone sealings (the steam power and the high temperature might
remove both glue and silicone).
In these cases the instruction leaflets relating to the product to be cleaned should be referred to; if
these are not available, short tests should be carried out, applying low steam power, on unobtrusive
areas or samples of the products to be cleaned.
More over, especially during winter, glass should be "preheat" by spraying middle/lowsteam power
with the nozzle, which should beheld 30/40 cm away from the glass. After this procedure, cleaning
can be carried out according to the instructions.
3