Table of Contents
Advertisement
TRENDnet User's Guide
System
Device Management
System > Change Password
This section provides instructions on configuring the login credentials to the TPL-430AP's
Interface.
Note: It is highly recommended that you configure the login password.
1. Log in to TPL-430AP.
2. Go to System and select the Change password menu.
3. In the Old Password field, enter the old password. By default, the password is admin)
4. Enter the New Password, and enter it again in the Confirm Password field to verify.
5. Click Save to save your settings.
Note: If you change the access point login password, you will need to access the access
point management page using the User Name "admin" and the new password.
© Copyright 2017 TRENDnet. All Rights Reserved.
Restore
System > Restore
You may want to restart or restore your powerline access point if you are encountering
difficulties with your access point and have attempted all other troubleshooting.
1. Log in to TPL-430AP.
2. Go to System and select the Restore menu.
3. Click Restore to reset the device back to factory default settings.
4. Click OK to confirm your selection.
5. Your TPL-430AP will take about 3 minutes to reset and reboot back to factory default
settings.
Administrator User Name
Administrator Password
Access Point IP Address
Access Point Subnet Mask
Wireless Interface
Wireless Network Name/Encryption
(WPA2-PSK AES)
Powerline Encryption Key
TPL-430AP / TPL-430APK
admin
Please refer to sticker or
device label
http://tpl-430ap
/
192.168.10.1
255.255.255.0
Enabled
Please refer to sticker or
device label
HomePlugAV
11
Hide quick links:
Advertisement
Table of Contents
