Component Overview; Use - P.Lindberg 9043623 Original User Manual

Component overview

Spout
Transport –
drawbar
Rotor

Use

The woodchipper is designed to chip wood from newly felled trees. Branches should
not be thicker than 10 cm in diameter. Only use the machine for the purpose it is
designed for. The rotor has two blades, each 30 cm in width, and is driven via V-belts
from an engine with an electrical starter. The rotor's centrifugal power ensures that
the woodchip is ejected from the machine's spout. The angle of the rotor's wings
where the blades are securely bolted and the position of the counterknive ensure that
the branch is automatically pulled into the machine without manual feeding.
Before use, check that the bolts on the blades and counterknive are secure. After
using for one hour, check that the bolts are still secure and that the distance between
the blades and counterknive is 0.5 mm. If necessary, adjust the counterknife for this
distance.
Check that the positioning of the machine is stable on the ground and check that it
cannot tilt in any way. The hazard zone on the output side of the machine must be
respected to avoid serious personal injury when woodchip is ejected from the spout.
P. Lindberg A/S
Tel.: +45 70212626
3
Sdr. Ringvej 1
6600 Vejen, Denmark
Funnel
Engine
Transport
Emergency stop
MAN 9043623 EN V2
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk