Current Time Setting - Vitek VT-3592 BK Manual Instruction

ENGLISH
•
•
•
•
•
•
•
•
THE UNIT IS INTENDED FOR
HOUSEHOLD USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or stor-
age at low temperature keep it
M VT-3592_105x148.indd 4
During the radio operation place it
out of reach of children.
This unit is not intended for usage
by children.
The unit is not intended for usage
by physically or mentally disabled
persons (including children) or
by persons lacking experience or
knowledge if they are not under
supervision of a person who is
responsible for their safety or if
they are not instructed by this per-
son on the usage of the unit.
Never use the radio if the power
cord or the plug is damaged, if the
unit works improperly or after it
was dropped.
Do not attempt to repair the unit.
Do not disassemble the unit by
yourself, if any malfunction is
detected or after it was dropped,
unplug the unit and apply to any
authorized service center from
the contact address list given in
the warranty certificate and on the
website www.vitek.ru.
To avoid damages, transport the
unit in the original package only.
For environment protection do not
discard the unit with usual house-
hold waste after its service life
expiration; apply to a specialized
center for further recycling.
Keep the unit out of reach of chil-
dren and disabled persons.
for at least three hours at room
temperature before switching on.
USING THE RADIO
Battery installation
•
Open the battery compartment
lid (11) and insert 3 UM-2 batter-
ies (not supplied), strictly follow-
ing the polarity.
•
Close the battery compartment
lid (11).
Note:
–
do not use old and new batter-
ies together or different types of
batteries;
–
when the radio operation is
unstable, check the batteries and
replace them if necessary;
–
remove the batteries if you are
not planning to use the radio for
a long time.
•
Before connecting the radio to the
mains, make sure that your home
mains voltage corresponds to the
unit operating voltage.
•
If the unit is mains-supplied, insert
the power cord jack (14) into the
connector (13) «AC IN» and the
power cord plug into the socket.
The batteries installed in the battery
compartment will be switched off.

CURRENT TIME SETTING

Make sure that the radio is
1.
switched off.
Press and hold down the button
2.
(3) «CLOCK SET», the time format
symbols will be flashing on the
display (2).
Press the button (4) «PRESET»
3.
to select the 12 hour format or
24 hour format.
4
07.07.2017 15:28:56