Troubleshooting - Whirlpool WSFE2B19UK User Manual

TROUBLESHOOTING

Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
PROBLEMS POSSIBLE CAUSES
The dishwasher The appliance has not been plugged
won't start in properly.
or does not
Power outage.
respond to
com-mands.
The dishwasher door is not closed.
It does not respond to commands.
The dishwasher
won't drain.
The drain hose is bent.
The sink drain pipe is blocked.
The dishwasher
The dishes are rattling against each.
makes
excessive noise.
An excessive amount of foam has
been produced.
The dishes are The crockery has not been arranged
not clean. properly.
The spray arms cannot rotate freely,
being hindered by the dishes.
The wash cycle is too gentle.
An excessive amount of foam has
been produced.
The cap on the rinse aid compartment has
not been shut correctly.
T h f e t l i r e
There is no salt.
MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, see the Use and Care Guide
The Use and Care Guide can be obtained by:
• After-Sales Service; phone number see in warranty booklet.
• Download from website: www.whirlpool.com.hk
11
s i o s e l i d o c r o l g g e . d
SOLUTIONS
Insert the plug into the socket.
The dishwasher starts automatically when the power returns.
Vigorously push the door until you hear the "click".
Switch o the appliance by pressing the ON/OFF button, switch it back
on after approximately one minute and reset the program.
nishes.
Check that the drain hose is not bent (see INSTALATION INSTRUCTION).
Clean the sink drain pipe.
Clean the lter (see CLEANING THE FILTER ASSEMBLY).
Position the crockery correctly (see LOADING THE RACKS).
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see FILLING THE DETERGENT DISPENSER). Reset dishwa-
sher by pressing the DRAIN button (see OPTIONS AND FUNCTIONS) and run
new program without detergent.
Arrange the crockery correctly (see LOADING THE RACKS).
Arrange the crockery correctly (see LOADING THE RACKS).
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not suitable for use
in dishwashers (see FILLING THE DETERGENT DISPENSER).
Make sure the cap of the rinse aid dispenser is closed.
C e l n a h t f e t l i r e s a e s m b y l (see CARE AND MAINTENANCE).
Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service, you
must provide the codes shown on the rating
plate attached to the left or right side inside the
door of the dishwasher. The phone number is
listed in the warranty booklet or on the website:
www.whirlpool.com.hk
IEC 436
:
11