Table of Contents
Advertisement
Quick Links
DAILY REFERENCE
GUIDE
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance, please
register your appliance on: www.whirlpool.eu/register
Before using the appliance carefully read Safety Instructions.
PRODUCT DESCRIPTION
APPLIANCE
7
8
9
11
Service:
0000 000 00000
12
CONTROL PANEL
1
1.
On-Off/Reset button with indicator light
2.
Program selection button with indicator light
3.
Half Load button with indicator light / Keylock
4.
Eco program indicator light
5.
Keylock indicator light
6.
Display
7.
Program number and remaining time indicator
2
3
4
5
6
You can download the Safety Instructions and the
User Manual, by visiting our website docs.whirlpool.eu
and following the Instructions on the back of this
booklet.
1.
Upper rack
1
2.
Foldable flaps
3.
Upper rack height adjuster
2
4.
Upper spray arm
5.
Lower rack
6.
Cutlery basket
3
7.
Lower spray arm
8.
Filter Assembly
4
9.
Salt reservoir
5
10. Detergent and Rinse Aid dispensers
6
11. Rating plate
12. Control panel
10
7
8
9 10
11
12
8.
Tablet (Tab) indicator light
9.
Closed water tap indicator light
10. Rinse Aid refill indicator light
11. Salt refill indicator light
12. Sani Rinse button with indicator light / Tablet (Tab)
13. Delay button with indicator light
14. Start/Pause button with indicator light / Drain out
13
14
EN
1
Advertisement
Table of Contents
Related Manuals for Whirlpool CONTROL PANEL
Summary of Contents for Whirlpool CONTROL PANEL
- Page 1 DAILY REFERENCE GUIDE THANK YOU FOR BUYING A WHIRLPOOL PRODUCT. You can download the Safety Instructions and the In order to receive a more complete assistance, please User Manual, by visiting our website docs.whirlpool.eu register your appliance on: www.whirlpool.eu/register and following the Instructions on the back of this booklet.
- Page 2 The salt reservoir is located in the lower part of the dishwasher (see PRODUCT DESCRIPTION) and must be filled when the SALT REFILL indicator light in the control panel is lit. 1. Remove the lower rack and unscrew the reservoir cap (anticlockwise).
-
Page 3: Programs Table
ECO program data is measured under laboratory conditions according to European Standard EN 60436:2020. Note for Test Laboratories: For information on comparative EN testing conditions, please send an email to the following address: dw_test_support@whirlpool.com Pre-treatment of the dishes is not needed before any of the programs. - Page 4 OPTIONS AND FUNCTIONS OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL). If an option is not compatible with the selected program see PROGRAMS TABLE, the corresponding LED flashes rapidly 3 times and beeps will sound. The option will not be enabled.
-
Page 5: Loading The Racks
LOADING THE RACKS UPPER RACK LOWER RACK Load delicate and light dishes: For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids should glasses, cups, saucers, low salad ideally be placed at the sides to avoid interferences with the spray arm. bowls. -
Page 6: Daily Use
DAILY USE MODIFYING A RUNNING PROGRAM 1. CHECK WATER CONNECTION Check that the dishwasher is connected to the water supply and that If a wrong program was selected, it is possible to change it, provid- the tap is open. ed that it has only just begun: press and hold the ON/OFF button, the machine will switch off. -
Page 7: Care And Maintenance
CARE AND MAINTENANCE CLEANING THE FILTER ASSEMBLY CLEANING THE SPRAY ARMS Regularly clean the filter assembly so that the filters do not clog and On occasions, food residue may become encrusted onto the spray arms that the waste water flows away correctly. and block the holes used to spray the water. -
Page 8: Troubleshooting
Air in water supply. Check water supply for leaks or other issues letting air inside. are blinking rapidly. Policy and standard documentation and additional product information can be found by: Visiting our website docs.whirlpool.eu • • Using QR Code •...