Table of Contents
Advertisement
Help Guide
Wireless Stereo Headset
h.ear in 3 Truly Wireless (WF-H800)
Initializing the headset to restore factory settings
If the headset does not operate correctly even after resetting, initialize the headset.
Place the headset into the charging case, leave the lid of the charging case open, then press and hold the buttons on
both the left and right units for about 10 seconds. Release your fingers when the indicators (red) of the headset start
flashing.
The indicators (blue) flash 4 times (
etc. to the factory settings, and deletes all pairing information. In this case, delete the pairing information for the headset
from the device and then pair them again.
If the headset does not operate correctly even after initializing, consult your nearest Sony dealer.
Note
Check that the indicators (red) on both the left and right units light up before you press the buttons on both the left and right units
of the headset.
If you have updated the software after purchasing the headset, even if you initialize the headset, the software is retained updated.
When you initialize the headset to restore the factory settings after you change the language of voice guidance, the language will
also return to the factory setting.
), and the headset is initialized. This operation resets volume settings,
5-007-451-11(1) Copyright 2019 Sony Corporation
94
Advertisement
Table of Contents
