Lexus ES 300h Owner's Manual page 273

272
4-5. Using the driving support systems
*2
or 1 mph (1.6 km/h)
switch is pressed
Large adjustment: Increases or
decreases in 5 km/h (3.1 mph)
*2
mph (8 km/h) increments for as long
as the switch is held
In the constant speed control mode
(P.273), the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*2
mph (1.6 km/h) each time the switch is
pressed
Large adjustment: The speed will continue
to change while the switch is held.
*1
: When the set speed is shown in "km/h"
*2
: When the set speed is shown in "MPH"
Changing the vehicle-to-vehicle
distance (vehicle-to-vehicle dis-
tance control mode)
Pressing the switch changes the vehi-
cle-to-vehicle distance as follows:
1
Long
2 Medium
3
Short
The vehicle-to-vehicle distance is set auto-
matically to long mode when the power
switch is turned to ON mode.
each time the
If a vehicle is running ahead of you, the pre-
ceding vehicle mark
played.
*1
or 5
Vehicle-to-vehicle distance set-
tings (vehicle-to-vehicle dis-
tance control mode)
Select a distance from the table below.
Note that the distances shown corre-
*1
or 1
spond to a vehicle speed of 80 km/h
(50 mph). Vehicle-to-vehicle distance
increases/decreases in accordance
with vehicle speed. When the vehicle is
stopped by system control, the vehicle
stops at a certain vehicle-to-vehicle
distance depending on the situation.
Resuming follow-up cruising
when the vehicle has been
stopped by system control (vehi-
cle-to-vehicle distance control
mode)
After the vehicle ahead of you starts
off, press the +RES switch.
Your vehicle will also resume follow-up
cruising if the accelerator pedal is
A will also be dis-
Vehicle-to-vehicle
Distance options
Approximately 50
Long
m (160 ft.)
Approximately 40
Medium
m (130 ft.)
Approximately 30
Short
m (100 ft.)
distance