Replacing Oil Line And Grommet - Echo CS-600 Service Manual

50
CS-600
SAW CHAIN LUBRICATION SYSTEM

7-4 Replacing oil line and grommet

1. Pull out oil strainer from oil tank (Refer to "7-1
C
Inspecting oil cap and strainer") and remove oil
strainer from oil line.
2. Remove auto-oiler assembly from crankcase
(Refer to "7-2 Inspecting auto-oiler assembly and
oil line").
A
3. Remove oil line with grommet, from crankcase.
4. Insert new oil line (A) to new grommet (B).
5. Assemble grommet (B) in grommet hole (C) of
crankcase.
B
F
6. Pass oil line (A) under brake band (D) and set
E
clips (E) on the end of oil line and oil outlet line (F).
D
A
7. Connect oil line (A) and oil outlet line (F) to auto-
F
oiler assembly as shown.
A 8. Pull out the other end (a) of oil line from oil cap
hole.
9. Reinstall auto-oiler assembly to crankcase, ad-
justing oil line length by pulling the other end (a) of
oil line.
G
10. Install oil strainer (G) to the other end (a) of oil
line.
11. Put oil strainer and oil line in oil tank. Make
sure oil strainer can move freely in oil tank.
NOTE: If oil strainer cannot move freely in oil tank,
a
chain oil may not be supplied properly.