Assembling Brake Parts - Echo CS-600 Service Manual

CS-600

6-2 Assembling brake parts

D
B
E
G
c2
H
CHAIN BRAKE SYSTEM
b
a
F
1. Set brake band (A) together with spacer (B),
brake connector (C) and spacer (D), placing the
notch (b) of spacer (B) as shown. Install roller (E)
through brake band hole (a).
C
A
2. Set side plate (F) on crankcase groove as
shown.
3. Install brake band and other parts (refer to the
above 1.) on crankcase as shown. Make sure the
pin (c1) of brake connector (C) is engaging with
the groove (G) of crankcase.
C
c1
4. Slide in compression spring (H) to the end (c2)
of brake connector as sown.
5. Install compression spring (H) in crankcase, by
pushing with longnose pliers etc. as shown.
6. Apply molybdenum grease on entire compres-
sion spring and other friction parts.
7. Reinstall guide plate, brake cover and other
parts.
F
C
45