Inspecting Auto-Oiler Assembly And Oil Line - Echo CS-600 Service Manual

48
CS-600
SAW CHAIN LUBRICATION SYSTEM

7-2 Inspecting auto-oiler assembly and oil line

1. Referring to "5-1 Inspecting clutch parts", re-
move clutch parts.
C
2. Remove inner guide plate (A).
3. Remove two bolts (B).
4. Disconnect oil outlet line (C) and oil line (D) from
auto-oiler assembly (E), and remove auto-oiler as-
sembly.
B
D
E A
5. Inspect auto-oiler assembly (E) for discoloration
D
or deformation. Inspect gear (e1) for wear and
damage. Inspect oil inlet (e2) and outlet (e3) for
E
clog. Replace as required.
G F
6. Connect Pressure tester 897803-30133 (F) to oil
line (D) with pipe joint V186-000020 (G).
7. Tighten oil cap and apply pressure approx. 9.8
2
kPa (0.1kgf/cm ) (1.4psi).
8. Pressure should not drop. If the pressure drops,
leakage may occur at oil cap, oil cap O-ring, mat-
ing surface of oil tank, oil line, grommet, or oil tank
vent. Inspect them and replace defective part(s)
with new parts as required.
e2
e1
e3