Replacing Starter Pawl - Echo CS-600 Service Manual

Hide thumbs Also See for CS-600:

Table of Contents

CS-600

2-4 Replacing starter pawl

STARTER SYSTEM

1. Remove starter assembly from unit.

2. Loosen bolt (A) and remove washer, pawl (B),

spacer (C) and torsion spring (D). Replace dam-

aged or worn parts.

NOTE: When it is hard to loosen bolt, install Piston

stopper 897537-30130 (E) in spark plug hole to

stop crankshaft rotation and remove bolt easily.

3. Install torsion spring, spacer, pawl, washer and

bolt. To avoid pinching of torsion spring, install

these parts without setting the end (F) of torsion

spring on starter pawl. The bolt is pre-coated with

sealant on the thread. If the sealant is peeled off,

apply thread locking sealant (Loctite #242, Three-

Bond #1324 or equivalent).

4. Using ﬁ ne wire (G) or appropriate tool, place the

end (F) of torsion spring on pawl (B), by hooking

and passing under pawl as shown. Remove fine

wire or tool.

5. Make sure pawl can move smoothly. If it does

not move smoothly, check parts for correct installa-

tion.

Table of Contents