CS-310
7-5 Replacing auto-oiler assembly
SAW CHAIN LUBRICATION SYSTEM
A
B
E
F
G
E
F
1. Tap 5-mm (M5 - Pitch 0.8mm) thread in the bore
of auto-oiler (A).
2. Use auto-oiler puller Y089-000130 to remove
auto-oiler.
Y089-000130
3. Set distance (B) of Y089-000130 to 15-20 mm
(0.59-0.79 in).
4. Put bolt (C) through washer (D) as shown. Put
bolt (C) through pipes (E) and (F).
5. Screw bolt tip (c) into the bore of Auto-oiler (A).
A
C
c
D
6. Holding inner pipe (E) with a wrench (G), rotate
outer pipe (F) anticlockwise by another wrench, to
pull out auto-oiler.
49