Step 4 - Tighten Front Face Screws; Step 5 - Replace Screws Holding Front Face To Base; Step 6 - Drill Two Holes For Hay Rack - Omlet Eglu Conversion Kit Quick Start Manual

Step 4 - Tighten Front Face Screws

Tighten the screws until the faces in the
circle butt up against each other.
Tighten

Step 5 - Replace Screws Holding Front Face to Base

Pull back on the front face while replacing
the two screws. Stop turning the screws
as soon as they become tight so as not to
Pull
damage the thread.

Step 6 - Drill Two Holes For Hay Rack

Using a 5mm drill bit, drill a hole at the
Drill
bottom of each recess in the front face.
You have now finished the conversion and
can put the tray, feed bowl, hay rack and
water bottle into place.
If you have any problems converting your eglu call us on
0845 450 20 56 or email info@omlet.co.uk
Page3