If you turn the programme selector or
touch the control panel while the
childproof lock is active, the w 3 sec
indicator flashes briefly and a signal
sounds. The programme runs through
to the end unchanged.
Notes
The childproof lock can be activated
■
regardless of the appliance's status.
The childproof lock remains active,
■
even once the washing machine has
been switched off.
If the appliance is switched off while
■
the programme is running and the
childproof lock has been activated,
the programme will resume when the
appliance is switched back on.
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
To do this, touch the control panel Ü.
The indicator flashes. The machine is
paused and checks whether a top-up is
possible.
If the display ® goes out, a top-up is
possible. The door is then unlocked and
can be opened.
To continue the programme. touch Ü
again. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Follow the information on the display
panel.
The load display is not active during
■
reloading.
Operating the appliance
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the control panel Ü.
1.
Select another programme.
2.
And touch Ü again.The new
3.
program starts from the beginning.
Cancel the programme
For programs at high temperature:
Touch the control panel Ü.
1.
To cool the laundry: Select
2.
Полоскание (Rinse).
And touch Ü again.
3.
For programmes at low temperatures:
Touch Ü.
1.
Select Отжим (Spin) or Слив
2.
(Drain/Empty).
And touch Ü again.
3.
Programme end during rinse
hold
The Ü indicator flashes in the display
panel, and the preset spin speed and
remaining programme length are
displayed for the selected programme.
Continue the programme by:
Touching Ü on the control panel or
■
Changing the spin speed and then
■
touching Ü or
Selecting the Антисмин. (Less
■
iron) S setting and then touching Ü
or
Turning the programme selector to
■
Слив (Drain/Empty) and then
touching Ü.
Programme end
End lights up in the display panel and
the Ü and ® displays are off.
en
31