Before Washing For The First Time; Transportation - Siemens WM T Series Instruction Manual And Installation Instructions

Positioning and connecting
en
The mains plug must be freely
■
accessible at all times. If this is not
possible, in order to comply with the
relevant safety regulations, a switch
(2-pole switch-off) must be built into
the permanent installation in
accordance with electrical
installation regulations.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The washing machine has been
thoroughly tested before leaving the
factory.To remove any water that may
be left over from testing, run the first
wash cycle without any laundry.
Notes
The washing machine must be
■
correctly installed and connected.
See ~ Page 12 onwards
Never use a damaged machine.
■
Notify your after-sales service.
Preparatory work:
Check the machine.
1.
Fill the ¨ and M dispensers.
2.
~ Page 39
Remove the protective film from the
3.
control panel.
Plug in the mains plug.
4.
Turn on the tap.
5.
Run the program without laundry:
Switch on the appliance.
1.
Close the door (do not load any
2.
laundry).
Set the Oчиcтка барабана (Drum
3.
Clean) 90 °C program.
Open the detergent drawer.
4.
Pour approx. 1 litre of water into the
5.
manual dosing compartment.
Pour all-purpose detergent into the
6.
manual dosing compartment.
18
To prevent foaming, only use
Note:
half the amount of detergent
recommended by the detergent
manufacturer.Do not use detergents
intended for woollens or delicates.
Close the detergent drawer.
7.
Start the program.
8.
Switch off the appliance once the
9.
program has finished.
Your washing machine is now ready to
use.

Transportation

E.g. when moving house
Preparatory work:
Turn off the tap.
1.
Release the water pressure in the
2.
supply hose: ~ "Filter in the water
supply blocked" on page 46
Disconnect the washing machine
3.
from the mains power supply.
Drain the remaining water: ~ "The
4.
drain pump is blocked, emergency
draining" on page 45
Detach the hoses.
5.
Empty the dispensers. ~ Page 41
6.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.