Specifications; Radio Specifications; Attachments/Accessories - Toro Pro Force 44553 Operator's Manual

Choke Control
To start a cold engine, move the choke control lever
(Figure 9) to the O position.
N
1. Choke control
2. Hour meter
Hour Meter
The hour meter (Figure
machine operation.
Diagnostic Light
The diagnostic light (Figure
hour meter and indicates machine fault codes. After
you turn the key to the R
light will illuminate for 5 seconds, turn off for 5
seconds, and then begin flashing 3 times a second
until you push a button on the handheld remote. If the
light turns on for 5 seconds and then starts blinking 10
times a second (with or without a 5 second pause)
there is a fault with the machine; refer to
Fault Codes (page 37).
Note:
If you have a button pressed on the handheld
remote when you start the machine, the light will not
flash 3 times a second after it turns off for 5 seconds.
Figure 9
3. Ignition switch
9) indicates the total hours of
10) is located below the
position, the diagnostic
UN
Resolving
1. Diagnostic light
g029819

Specifications

Radio Specifications

Frequency
Max output power

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
12
Figure 10
2.4 GHz
19.59 dBm
www.Toro.com for a list of all
g029824