TDK-Lambda CUS600M Instruction Manual page 4

NOTE
 Take note that traces of sheet metal processing be left in our power supplies.
 When disposing product, follow disposal laws of each municipality.
 Published EMI (CE, RE) or immunity is the result when measured in our standard measurement conditions and might not satisfy
specification when mounted and wired inside end-user equipment. Use the product after sufficiently evaluating at actual end-user
equipment.
 When exporting our products, apply for necessary permissions as required by rules and regulations of Foreign Exchange and Foreign
Trade Control Act.
 Catalogue, contents of the instruction manual may be changed without a prior notice. Refer to latest catalogue or instruction manual.
 Reproduction or reprinting the instruction manual or its portion is forbidden without our permission.
LONG-TERM STORAGE METHOD AND LONG-TERM STORAGE PERIOD
 Please keep the product in carton box.
 Please do not apply excessive vibration, shock or mechanical stress applied directly to the product.
 Please keep away from direct sunlight.
 For long-term storage temperature and humidity, the following conditions shall be used as a guideline:
Temperature range : 5℃～30℃
Humidity range : 40%～60%RH
Please keep away from the places where temperature and humidity can change drastically. It can cause condensation on the product or
deterioration.
 For long-term storage period, we recommend to use within 2 years after receiving the product.
< Soldering and PCB mounted products: On Board, Power Module and etc >
For products that have been received for more than 1 year, please check lead oxidation and solderability.
In addition, SMD type products may have MSL (Moisture Sensitivity Level) provision.
Please be sure to read the instruction manual and delivery specifications.
< Unit type or PCB type of products: the product is used an aluminum electrolytic capacitor >
There is tendency that the leakage current of an aluminum electrolytic capacitor may increase when stored without using
for a long time. This phenomenon can be improved by applying voltage to the aluminum electrolytic capacitor to reduce the
increased leakage current through the self-recovery effect of the electrolyte. For reference, before using products that have
been stored for a very long time, please warm-up first for 30 minutes or more without taking load.
< Criterion of warm up voltage condition >
(1) Implementation period: 1 year or above after the delivery.
(2) Electrical continuity condition.
Input voltage: Rating.
Load: 0A.
Ambient temperature: Normal temperature.
Time: 30 minutes or more.
4/22
TDK-Lambda
CUS600M
INSTRUCTION MANUAL