Table of Contents
Advertisement
> Once the plug is inserted, ZERO becomes ACTIVE and is
ready for the FIRST ACTIVATION process.
> The display is activated (with a beep emitted), water level
light on and steady and filter light on and flashing and
buttons off.
ZERO ZERO DISPLAY STATUS:
> The water level light goes out and only the intermittent natural water
button turns on.
> The filter light stays on intermittently.
USER ACTIVITY:
> Position a suitable container (3 L) to collect the water that is
dispensed. This step will activate your filter. The collected water
must not be ingested but to avoid wasting it you can use it for your
plants.
ZERO ZERO DISPLAY STATUS:
> The natural water button comes on;.
> The filter light stays on intermittently.
USER ACTIVITY:
> Fill the external tank up to the level;
> Press the natural water button (which becomes steady during
dispensing); the filter light remains intermittent;
> The natural water button starts to flash.
ZERO ZERO DISPLAY STATUS:
> The intermittent natural water button comes on;
> The filter light stays on intermittently.
USER ACTIVITY:
> Press the natural water button again (which becomes steady
during dispensing); the filter light remains intermittent;
> The natural water button starts to flash
14
C
D
E
F
CALIBRATING THE BOTTLE:
> Fill the external tank up to the level;
> Remove the container you previously placed under the water
dispenser and replace it with the supplied Happy Frizz bottle;
> The natural water button automatically acts as a guide while
flashing;
> Press the natural water button;
> When the correct level is reached (water level mark on the bottle),
press the natural water button again to stop dispensing.
Now you have calibrated your bottle of ambient water.
> Remove the external tank and the filter;
> Be sure to shake the filter with the tip at the top to remove the air
inside.
> At the end of the operation, refit the filter, fill the tank and place it
back on its seat.
ZERO DISPLAY STATE:
> The crossed drop light goes out and the intermittent cold water
button comes on.
> The filter light stays on intermittently.
USER ACTIVITY:
> Place a suitable container on the drip tray again.
NOTE: If the user does not fill the tank, it does not have enough water
to fill the internal tank, then the external tank level light comes on and
when it turns off (water is available again) the machine restarts with
the internal tank filling phase
ZERO DISPLAY STATE:
> The internal water tank is refilled;
> The cold water light comes on;
> The filter light stays on intermittently.
USER ACTIVITY:
> Press the cold water button (which becomes steady during the filling
phase).
15
G
H
I
Advertisement
Table of Contents
