Happy Frizz ZERO Use And Maintenance Manual page 12

IT'S TIME FOR SANITISATION - What happens to my ZERO?
COMPLETE PROCEDURE OF SANITISATION/DECALCIFICATION /
FILTER CHANGE..
STAFF NOTE
ZERO invites you to carry out the sanitisation/descaling and filter change procedure every 1500 L, or every 6
months or if the ZERO system has not been used for 1 week or more.
The next few steps may seem tedious or long; in reality it was more difficult to write them in this manual than
to actually carry them out. In any case ZERO will accompany you through these phases, step by step. It is
very important that you strictly follow the instructions below.
The first stage of the procedure is to make sure that the sanitising/descaling powder arrives throughout the
circuit and the second part is used to rinse your ZERO well. Shall we begin?
WHAT DO YOU NEED?
> PACK KIT for sanitising/descaling and filter change (p. 21).
> 1 WATER CONTAINER OF AT LEAST 3L (we recommend a pot).
> 1 SUPPORT BASE for the container (we recommend using a kitchen cutting board).
NOTE: to keep the container flat,
use a support, for example
a kitchen cutting board.
If this light has come on it is a
SANITISATION/DECALCIFICATION time
▶
WARNINGS:
> if you are not ready (Kit available and a 3L container) do not press
the button to perform the procedure.
> in case of CONNECTION TO THE WATER MAINS CLOSE THE "T"
VALVE (see page 21).
ZERO DISPLAY STATE:
> The magenta button with the "cleaning filter" symbol is on. This
means that it is time for sanitisation and filter change.
USER ACTIVITY:
> Press the magenta icon for 5 seconds to start the sanitisation
procedure.
22
RECOMMENDATION:
water, there may be some difficulty in rotating the filter.
In this case, we advise you to try using a nutcracker or a set
of pliers by pressing on the secure grip fins.
"Good, you have removed the used filter.
you when to do so (see point 15). Let's continue with the sanitisation procedure".
USER ACTIVITY:
> Fill the external tank with tap water up to the level;
> Open the sanitising sachet and pour it into the external
previously filled tank;
> Use a spoon
▶
WARNINGS FOR THE USE OF SANIKIT POWDER:
The sanitising powder should not be swallowed. Avoid contact with the eyes.
Attention.
H319 Causes severe eye irritation.
H411 Toxic for aquatic organisms with long-lasting effects.
Wash skin thoroughly after use. Do not disperse in the environment. Wear protective gloves/clothing and
protect the eyes/face.
IN CASE OF CONTACT WITH THE EYES:
1
Rinse thoroughly for several minutes. Remove any contact lenses if it is easy to do so. Continue to rinse. If eye irritation
persists, consult a doctor. Collect any spilled material.
ZERO ZERO DISPLAY STATUS:
> The magenta button with the "cleaning filter" symbol remains on;
> The orange light with the crossed filter symbol has come on and is
intermittent;
> The water supply buttons go out.
USER ACTIVITY:
> Remove the external tank and the used filter by turning it anti-
clockwise by approximately 90° until it is released, then lift it.
in case of particularly hard/calcareous
DO NOT INSERT THE NEW FILTER IMMEDIATELY.
ZERO DISPLAY STATE:
> The magenta button with the cleaning filter symbol remains on;
> The orange light with the crossed filter symbol remains on and is
intermittent;
> The red water level light is on.
USER ACTIVITY:
> Put the external tank back in place with the sanitiser dissolved
in the water;
> Place under the water dispenser (above the drip tray) a
suitable container (min. 3 litres).
23
2
Zero will inform
3
4