Super Freeze And Low Ambient Switch; Display; Fr Den - BORETTI BKVD-179 Operating Instructions Manual

Super Freeze and low ambient switch

(In some models)
a) Super freezing:
If ambient temparature is more than 18°C,
This switch can be used as superfreeze switch.
Super freeze switch should be used for free-
zing the fresh food or when the RED lamp on
the head panel is ON. (RED lamp on the head
panel becomes ON when there is insufficient
cooling).
The appliance will work longer when you acti-
vate this switch. So after you get the cold con-
dition (or the Red lamp on the head panel is off)
you must return to previous position.
At the ambient temperature more than 18°C, if
superfreezing function doesn't want to be used,
it must always be set to OFF position.
b) Low ambient performance:
If ambient temparature is less than 18°C,
this switch can also be used as a low ambient
switch for good low ambient performence.
In low ambient temperatures, this switch heats
the fridge part to prevent extra cooling / free-
zing.
Super freeze light (SF light):
Lights orange, when the SF button is turned
on.
Power light:
Lights green automatically, when the appliance
is connected to the power supply.
0 : OFF Position.
I : ON Position.
Low ambient temperature control switch
Alarm light:
Lights red, when the temperature rises to a
critical point in side the freeze.
Turning On The Appliance
Once the appliance has been connected to the
power supply make sure that the green lamp
is on. Then turn the refrigerator thermostat
dial and the freezer thermostat dial to positi-
ons between 2-4. (Note that; for best internal
temperature the indicator in the refrigerator
and freezer thermostat should be positioned
between 2 and 4.)
• When you first switch on the appliance, for
starting a suitable cooling, the appliance
should work 24 hours continuously until it
cools down to sufficient temperature.
• During this time do not open the door fre-
quently and do not place a lot of food inside
the appliance.
• If the unit is switched off or unplugged, you
must allow at least 5 minutes before restar-
ting or re-plugging the unit in order not to
damage the compressor.
NL
FR
D
EN
57