Husqvarna Viking Platinum Q 165 User Manual page 17

The laser light (for use with paper pantographs) attaches to a mounting post with a clamp. The mounting
post attaches to a threaded hole on the thread-path side of the Platinum Q|165.
To install the optional laser stylus
1. Place the nut on the laser stylus post with the
washer under it and thread the laser post into
the threaded hole, near the rear wheel base.
Turn until securely in place. Lock in place with
nut.
 NOTE: The washer will be under the nut
to protect the machine paint. You can also
mount the laser on an unused spool pin.
2. Insert the laser stylus into the laser clamp.
3. Slide the laser clamp over the post to the desired height and ensure it is secure.
4. Plug the laser's cable into the Laser Stylus Power Connector. When this cable is plugged in, the laser
receives power and is turned on. To turn off the laser, unplug the cable.
The laser projects a straight laser beam visible as a dot on surfaces it hits. Use the laser dot as a guide, or
stylus, to trace printed pantograph designs and stitch the continuous pattern onto a quilt.
The laser stylus can move in any direction by rotating the clamp on the post and pivoting the laser up or
down. To make an adjustment, loosen the black thumbscrews, position, and retighten.
 IMPORTANT: A label is attached to the laser's case and contains an arrow which indicates the
direction the laser light will shine when energized. The label must remain in place on the laser.
Removing the label voids the laser's warranty.
Laser Operation and Safety
Be sure the laser is attached to the machine and pointed downward toward the table before connecting it
to the port. Never point it in a direction that would project the beam into someone's eyes. If the laser
should stop working, ensure the plug is firmly seated into the Platinum Q|165 laser port.
16 |
powerquilter 1650 Quilting Machine User's Guide