Working With Interfaces; Status And Settings For Interfaces - F5 BIG-IP 1600 Platform Manual

Chapter 4

Working with interfaces

Status and settings for interfaces

interface speed pkts
Mb/s
1.1 UP 100 FD
1.2 UP 100 FD
Figure 4.2 The bigpipe interface show command output
4 - 4
You can perform configuration tasks such as displaying interface status and
settings and setting the media type using the bigpipe utility.
When using the bigpipe interface command, you can either apply the
command to all interfaces or to a specific interface key (for example, 1.1).
From the command line interface, use the following syntax to display the
current status and the settings for all installed interfaces:
b interface show all
Figure 4.2 shows an example of the output you see when you issue this
command on the active unit of an active/standby configuration.
pkts pkts pkts
in out drop coll
0 213 0
20 25 0
Use the following syntax to display the current status and the setting for a
specific interface:
b interface <interface_key> show
bits bits errors trunk STP
in out
0 0 74.2K 0
0 28.6K 33.9K 0