Steps During Initial Operation - Baier PROMETHEUS Series Instruction Manual

Initial operation

6.2 Steps during initial operation

Moving wing
Danger of injury by squashing, shearing or collision, caused
by moving wing.
 Wing moves independently during initial operation.
 Keep danger area clear during initial operation.
 Prepare eletrical connections
 Refer to chapter 5.4
 Set configuration
 Refer to chapter 6.1
 Switch power supply on
 Control device in delivery status or after power cut:
Red LED blinks continuously twice with a short break of 1.5 sec
 Press RESET for 2 seconds
 Red LED blinks continuosly
 Check driving direction of motor
When pressing OPEN, wing has to open and when pressing CLOSE, wing has
to close
 When driving direction is wrong:
Swap motor cables (clamp 4 and 5), check driving direction again
 Press RESET again for 2 seconds
 Red LED lights up permanently,
Green LED lights up, when motor is active
 Drive performs a few runs.
 LEDs go out
 Red LED starts blinking continuosly
 In this state (about 30 seconds) additional complete cycles may be performed.
These cycles have to be triggered by user and are optional.
 After 30 seconds without any function, the LED goes out
 Check desired function
 In case of malfunction, check electrical connections and configuration
 Electrical connection, refer to chapter 5.4
 Configuration, refer to chapter 6.1
 Repeat initial operation, if necessary
 Initial operation is completed, when function is correct
24V motor control device for flush box mounting - Version 1.1
w w w . b a i e r - g m b h . d e
W A R N I N G
6
Prepare control device
Reset control device
...
...
...
...
Check function
15/22
Instruction manual