Mounting And Electrical Connection; Mounting In A Flush Box - Baier PROMETHEUS Series Instruction Manual

Mounting and electrical connection

5 Mounting and electrical connection
Wrong installation
 Install this control device only in flush boxes in dry
interior.

5.1 Mounting in a flush box

Dimensions of this control device are designed to fit into flush boxes according to
DIN 49073 or similar boxes. Pay attention to the maximum depth of the device
according to chapter 5.3.
Hint
Mounting of the flush box, cable laying, installation of switch range,
etc. is not explained in this document.
 Complete cable installation
 Disconnect main power supply
 Protect against power up
 Safety instructions, refer to chapter 2
 Prepare cables to motor and power supply for connection
 Install control device in flush box
 Carry out electrical connections
 Electrical connecntions, refer to chapter 5.4
 Fix control device with two screws
 Start initial operation
 Initial operation, refer to chapter 6
 Place cover (not included) over control device
 Plug switch through cover into control device
 Control device and switch are mounted
Cover
Switch
Figure 1 – Installation
24V motor control device for flush box mounting - Version 1.1
w w w . b a i e r - g m b h . d e
W A R N I N G
Power supply
Motor control device
Mount the control
device
Mount the switch
Flush box
(on site)
Instruction manual
5
9/22