Safety-Certified Identification - Emerson Rosemount 5900 Safety Manual

Safety Instrumented System
November 2019
1.4

Safety-certified identification

All Rosemount 5900 Radar Level Gauges and Rosemount 2410 Tank Hubs must be identified
as safety-certified before installing into SIS systems.
Rosemount 5900/2410 Series devices that have been considered for the functional safety
assessment, to which this manual applies.

Table 1-1. Rosemount Tank Gauging System (4-20 mA Analog Output)
Hardware
Software/Firmware
Table 1-2. Rosemount Tank Gauging System (Standard K1/K2 Relay Output)
Hardware
Software/Firmware
To identify a Rosemount 5900 and Rosemount 2410 safety-certified device:



4
Models with the S option code are IEC 61508 certified by an accredited 3rd party
agency for use in safety instrumented systems up to SIL 2.
Rosemount 5900 Radar Level Gauge
(type B)
Rosemount 2410 Tank Hub
Primary Field Bus
Secondary Field Bus
Rosemount 5900 Radar Level Gauge
(type B)
Rosemount 2410 Tank Hub
Rosemount 5900 Radar Level Gauge
(type B)
Rosemount 2410 Tank Hub
Relay Option 1xSPST
Relay Option 2xSPST
Rosemount 5900 Radar Level Gauge
(type B)
Rosemount 2410 Tank Hub
Verify the option code S in the model code, on the label affixed to the outside of the
transmitter head.
Check if a yellow label is affixed to the transmitter head for option code S.
Before doing any configuration, write down the Device Id from the label, and make
sure you are connected to the correct transmitter by verifying the same Device Id
in your communication device.
Safety Manual
00809-0400-5100, Rev AB
Table 1-1 lists the versions of the
Model Code S
Model Code S
Model Code B
Model Code A, B, C, D
Sw 1.B5 and further
Sw 1.B1 and further
Model Code S
Model Code S
Model Code 1
Model Code 2
Sw 1.B5 and further
Sw 1.B1 and further
Safety Instrumented System