Advertisement
ASSEMBLY OF HOPPING BAG
1. (Figure 10) Turn a rear hopper tube so that the brace holes in the middle of the tube face down. Slide
the tube through the two loops sewn to the top rear seam inside the hopper bag.
2. (Figure 11) Insert the two upper hopper side tubes through the stitched flaps on each side of the
hopper bag.
3. (Figure 11) Assemble the ends of the rear hopper tube onto the ends of the upper hopper side tubes.
4.
(Figure 12) Turn the second rear hopper tube so that the brace holes in the middle of the tube face
up. Assemble the ends of the rear hopper tube onto the ends of the lower hopper side tubes. Fasten
together using plastic plugs.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
10
00
12
Seite - 9 -
11
Advertisement
