Advertisement
REMOVE THE HARDWARE PACK AND ALL LOOSE PARTS FROM THE CARTON AND VERIFY
THAT ALL THE PARTS AND FASTERNERS SHOWN ON THE LAST PAGE ARE INCLUDED.
ASSEMBLY OF SWEEPER
Note: Right hand (R.H.) and left hand (L.H.) are determined from the operators' position while seated on
the Tractor.
1. (Figure 1) Assemble the angle bracket to the sweeper housing using a M8x16 hex bolt and a M8 hex
lock nut. Make sure the bracket is turned as shown and aligned straight with the housing and then
tighten.
3. (Figure 2) Assemble the R.H Hitch Tube to the sweeper housing using
Nut. Do not tighten yet. Repeat for the L.H hitch tube.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
ASSEMBLY
HEX LOCK
NUT M8
M6X40
HEX BOLT
1
ANGLE
BRACKET
M8X16
HEX
BOLT
2
M6x40
Hex Bolt and M6 Lock
Seite - 5 -
Advertisement
