Advertisement
IMPORTANT: Do not over bend the support rods during the following step. Over bending will cause the
steel rods to loose supporting tension.
10. (Figure 16) Tip the hopper onto it's back to assemble the two hopper support rods. Place the ends of
each rod into the upper and lower rear hopper tubes bending the rod just enough to fit into the holes in
the tubes.
11. (Figure 17) Feel along the stitched flap on the hopper bag to locate the lower hole in each upper
hopper side tube. Place a hole through both sides of the stitched flaps in alignment with the lower
hole.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
18
17
16
Seite - 11 -
Advertisement
