Pro-X XV-NE User Manual page 9

Table of Contents

Advertisement

6. Press ALL button to include all submachines into intercom system. By pressing
enable button 1-8, you can select the corresponding submachine to be included in
the intercom system. Submachines included in the system can hear from and send
messages to other submachines. Submachines excluded in the system cannot hear
from other submachines and can only send messages to Base Station.
7.Headset and speaker outputs volume can be controlled via volume control. Rotate
the knob clockwise to change the volume level from minimum to maximum.
8. When 2-Wire/4-Wire selector switch is in upper 2W position, 2-Wire cascade is
available. Other audio systems can be connected with the set via 2W port. When 2-
Wire/4-Wire Selector Switch is in bottom 4W position, 4-Wire cascade is available.
Other audio systems can be connected with the set via 4W port.
l
NOTICE: Keep the selector switch at 4W when you are not using 2-Wire or 4-
Wire cascade
9. Volume control of 2/4W IN is used to control the volume level of audio transmitted
from peripheral system to XV-NE. Volume control of 2/4W OUT is used to control the
volume level of audio transmitted from XV-NE to peripheral system.
10. Connect AUX IN port and AUX OUT port with auxiliary audio devices through
dedicated cables.
11. AUX IN turn button is used to control the volume level of audio transmitted from
peripheral system to XV-NE. AUX OUT turn button is used to control the volume
level of audio transmitted from XV-NE to peripheral system.
12. Connect TALLY Input with TALLY Output on your switcher through dedicated
cable to transmit TALLY signals from the switcher.
Submachine
1. Connect submachine with headset via 5-pin XLR port.
2. Install the antenna.
3. ON/OFF: Rotate Power Switch/Volume Control to "ON" to turn the submachine
on, you can hear "beep + Channel is X + remaining capacity" from the headset.
Rotate Power Switch/Volume Control to "OFF" to turn the submachine off.
4. Volume control: Rotate Power Switch/Volume Control clockwise to turn the
volume up, rotate it counterclockwise to turn the volume down.
5. Submachine sending audio messages: Press TALK button and send an audio
message, release the button to stop sending.
6. Setting: Press the light-touch setting button to manage submachine parameters
like frequency channels, background noise suppression level and PTT (TALK)
button usage pattern.
7. Charging: Connect USB charge port with the charger through USB charge cable
to charge the built-in Lithium-ion battery. CHG red LED stays on during charging
and FULL green LED stays on when it is fully charged.
7

Advertisement

Table of Contents
loading

Table of Contents