Operation - Pro-X XV-NE User Manual

Submachine
1 2 3 4
TALLY
1. ON/OFF/VOL: Power Switch/Volume Control
2. TALK: Non-locking Talk Button (PTT button)
3. SYS: Connecting LED Status Indicator
4. Tally: TALLY light socket
5. SMA Antenna
6. 5-pin XLR Headset Socket
7. USB Charge Port for Built-in Lithium-ion Battery
8. Clip
1. When the submachine is turned on, press OK and
to enter the setting menu.
2. Selection button
3. Selection button
4. Exit button. Press

Operation

Base Station
1.Install the antenna.
2.Apply 220V AC power to Base Station via AC power cord or power Base Station with a
12-17V DC power supply. AC IN will be the prior choice for power supply automatically
by inner circuit.
3.Turn on the power switch of Base Station, power LED lights up. Base Station is on with
the speaker or headset reports "beep + Channel is X (current signal channel)".
4.When HEADSET/MIC selector switch is in upper position, HEADSET LED lights up,
headset will be used for audio input and output; When HEADSET/MIC selector switch is
in bottom position, MIC LED lights up, gooseneck microphone and speaker will be used
for audio input and output separately.
5. Press TALK button, TALK LED status indicator lights up. Base Station is able to send
audio signals to submachines; press TALK button again, TALK LED status indicator lights
out, and Base Station is only able to receive audio signal and not able to send audio signals.
5 6
to return to main page.
7
6
8
1
OK
2
3
4