Installation
Pre-installation cabling
....................................................................................................................................................................................................................................
Procedure 4-2: Ethernet cabling - electrical
Purpose
This topic describes the procedures to be followed when connecting an electrical Ethernet
cable to the Alcatel-Lucent 9764 Compact Metro Cell Outdoor. The 9764 CMCO may
either be in a single configuration, or daisy chained to a second 9764 MCO.
Cabling ancillary items
The following backhaul cabling related ancillary items can be ordered from
Alcatel-Lucent:
10/100/1000Base-T electrical transceiver.
Electrical Ethernet cable with RJ45 connector to electrical SFP module.
Before you begin
Before you begin the following should be noted:
Equipment cabling should only be carried out by suitably trained or qualified
personnel and must comply with local and national electrical codes.
As a prerequisite, backhaul cable has been routed from the backhaul system to the
9764 CMCO.
One SFP port may be cabled for backhaul to the network while the other SFP port
may be cabled for daisy chaining to another 9764 MCO.
If the backhaul module is to be cabled after the 9764 CMCO is mounted onto a
surface then, in order to gain access to the backhaul module, the 9764 CMCO must
firstly be placed in the "service position".
....................................................................................................................................................................................................................................
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
4-11