Table of Contents
Advertisement
ENGLISH
Emptying and cleaning (Fig. H, I, J, K, L)
Press the dust bowl release button (4) and pull the dust
u
bowl (5) straight off as shown in figure H.
While holding the dust bowl over an appropriate waste
u
receptacle, pull out the filter assembly (19) as shown in
figure I.
Empty the dust bowl (5) into an appropriate waste recep-
u
tacle as shown in figure J
Rotate filter (20) counterclockwise to unlock and remove
u
it from the pre filter assembly (19). Gently remove any
debris.
Rinse out the dust-bowl with warm soapy water as shown
u
in figure L.
Wash the filters with warm soapy water as shown in figure
u
L.
Make sure the filters are dry before reassembling.
u
Refit the filters into the dust bowl and ensure that they are
u
correctly seated.
replace the dust bowl onto the hand vac making sure the
u
release latch (4) clicks into place.
Warning! Never use the appliance without the filters. Opti-
mum dust collection will only be achieved with a clean filter.
Removing and cleaning the rotary brushes
(Fig. M)
Warning! To reduce the risk of injury from moving parts,
disconnect the floor head from the stick vac before cleaning
or servicing.
To remove the rotary brush (6b), lift the plastic tab (6a)
u
located on the floor head (6).
Lift the rotary brush (6b) out of the floor head. Clear
u
the brushes of any hair or other debris that may have
accumulated.
Replace rotary brush, and secure plastic tab before
u
using vacuum.
Safe storage
The unit can be safely stored, when not in use, either by utilis-
ing the wall mount (17) or releasing the handle lock (12) and
lowering the handle (13) to allow for storage in confined areas.
Maintenance
Your BLACK+DECKER cordless appliance has been designed
to operate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance on cordless
appliances:
Run the battery down completely if it is integral and then
u
switch off.
Unplug the charger before cleaning it. Your charger does
u
not require any maintenance apart from regular cleaning.
8 8
(Original instructions)
Regularly clean the ventilation slots in your appliance/
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Replacing the filters
The filters should be replaced every 6 to 9 months and when-
ever worn or damaged. Replacement filters are available from
your BLACK+DECKER dealer.
Remove the old filters as described above.
u
Fit the new filters as described above.
u
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be recov-
ered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical Data
Voltage
Watt Hours
Weight with accessories
Australia & New Zealand
St Stanley Black & Decker
www.blackanddecker.com.au
www.blackanddecker.co.nz
Tel.1800 338 002 (Aust) or Tel. 0800 339 258 (NZ)
N663704
SVB520JW
SVB620JW
18V
21.6V
36Wh
43.2Wh
2.34Kg
2.39Kg
03/2019
Advertisement
Table of Contents
