System Set-Up - Kenwood TK-7150 Service Manual

5-2. Radio location
Select a convenient location for your control station radio
which is as close as practical to the antenna cable entry point.
Secondly, use your system's power supply (which supplies
the voltage and current required for your system). Make sure
sufficient air can flow around the radio and power supply to
allow adequate cooling.

SYSTEM SET-UP

Merchandise received
License and frequency
allocated by FCC
Choose the type of transceiver
Are you using
the remote kit?
NO
Are you using
the key label?
NO
Are you using
the voice scrambler/
ANI?
NO
Are you using
the ignition sense
cable?
NO
Transceiver programming
Are you using
the external speaker?
NO
DC power cable
Supplied cable or
KCT-23 M : 10 feet
KCT-23 M3 : 23 feet
Are you using
the keypad microphone?
NO
Are you using
the noise-canceling micro-
phone?
NO
Supplied microphone
Delivery
GENERAL / SYSTEM SET-UP
Frequency range RF power
136~174MHz
YES
KRK-9
Control cable KCT-22
M : 8 feet
M2 : 17 feet
M3 : 25 feet
YES
Supplied key label
YES
Modified of control unit
YES
KCT-18
See page 5.
A personal computer (IBM PC or compatible), programming interface (KPG-46),
and programming software (KPG-79D) are required for programming.
YES
External speaker KES-5
DC power supply KPS-10A
YES
KMC-28A
YES
KMC-27A
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and align-
ment procedures contained in this manual.
Type
50W TK-7150 K
See page 8.
See page 7.
See page 9.
See page 7.
See page 7.
Desk top microphone KMC-9C
TK-7150
3