How To Configure Your Nas - Philips SPD8025CC/05 User Manual

How to configure your NAS

10. The administrations console of your NAS
opens, allowing you to configure your
network hard disk
System management – Information
Here you can find general information on your
NAS after you logged in, such as:
System Information:
System Name
IP Address
Subnet Mask
Workgroup
Firmware Version
Date
Uptime
Total Storage
Available Storage
System management – Setup
Here you can configure general settings
Date and Time
You can either enter the date and time manually
or enable an internet time server.
To enter the date and time manually:
1. Disable 'set Clock from internet time server
(NTP)'
2. Fill in the correct date and time
3. Select accept to confirm your changes
To use the internet time server :
1. Enable 'set Clock from internet time server
(NTP)'
2. Fill in one of the below mentioned time server
addresses in the NTP server field
(corresponding with your region)
3. Select accept to confirm your changes
Make sure you are connected to the internet, when
you use the internet time server
17