Setting Up A New Locomotive; Registering Railcomplus - Esu CabControl DCC System User Manual

Edit locomotives
Figure 33: Edit locomotive – function icons
• Decide if the function should be continuous or momentary. Momentary
functions only remain "On" as long as you touch the icon. Continuous
output functions remain on until you touch the icon on the screen once
again.
• If you do not wish to use a particular function button (icon), simply disable
it with the switch at the top right.
A disabled function is not displayed on the "Running locomoti-
ves" screen. The other function buttons move up accordingly. If
you want to have a gap, however, then you may achieve this by
changing this feature in the settings menu.
Figure 34: Edit locomotive – Icon Names
***CREATE AND EDIT LOCOMOTIVES***

11.5. Setting up a new locomotive

When setting up new locomotives manually, the same remarks apply as de-
scribed for editing locomotives. Please note that one should never assign
a locomotive address twice. RailComPlus locomotives cannot be registered
manually at all. They will always register automatically. They can however be
edited once in the system.

11.5. Registering RailComPlus

Locomotives equipped with RailComPlus capable decoders automatically re-
gister with the CabControl command station. As soon as you have put a new
locomotive onto the track, it will be automatically detected. It will immedia-
tely be displayed on the main screen of your Mobile Control II.
Figure 34: RailComPlus locomotive is registered
If you wish to run this newly registered locomotive with your hand set, simply
touch "Open". After a short while this notice disappears automatically.
17