Connecting to WLAN
Figure 15: WLAN choices
Initial Setup and Unboxing Video
9.5. Starting App and selecting the command station
After the WLAN connection to the CabControl ICU has been established
successfully, you may start the actual Mobile Control II control App. This is
done by pressing the CabControl Icon the main screen.
First one must select the command station to which the Mobile Control II
should be connected. If there is only one system in range it will automatically
connect. If there is more than one system this cannot be done automatically,
because there may be several command stations in a network. Therefore a
list with the available command stations is displayed.
Select the command station to which you want to establish a connection.
Normally only one CabControl system will be shown. For better orientation
the software version as well as the IP address of the command station is
being displayed in addition to the host name of the command station.
The App memorizes which command station you have chosen.
During the next start, establishing a link will give priority to the
most recently employed command station. Should this be un-
successful, then the list of all available command stations will be
displayed.
9.5.1. Demo mode
If there is no command station in the network, then you may select the demo
mode in the context menu. You can test the device with the aid of this demo
mode.
Figure 16: Demo mode
10. The main screen
Finally the main screen of the Mobil Control II will be displayed. All main
functions are controlled from this screen. If there are already some locomoti-
ves in the system it will ask you to select one.
d)
a)
Figure 17: Main screen
c)
b)
11
Need help?
Do you have a question about the CabControl DCC System and is the answer not in the manual?