Installation
In order to install a memory upgrade you must:
1. Take suitable anti-static precautions as described
earlier.
2. Obtain access to the system board as described in
your Owner's Handbook .
The SIMM connectors are located on the right side of the
system board just behind the floppy drive bezel as shown
in the illustration below.
Note
When removing and installing SIMMs it is easiest to work
with the rear of the system unit towards you. As a result the
following instructions assume that you are viewing the
system unit from the rear.
BANK 2
BANK 3
BANK 1
SIMM SOCKETS
19