Mitsubishi Electric Apricot LS Pro Using Setup And Installing Add-Ons page 13

Local
This should be selected if the computer is to boot from an
internal hard disk or floppy drive.
It should be noted that when one of the remote boot
schemes described below is enabled it is not possible to
boot the computer from a local device. If you wish an LS
Pro that normally boots remotely to boot from a local
device, you must first use SETUP to select Local in the
boot device option group.
Ethernet RPL
If the computer is connected to an Ethernet network, and it
is to boot remotely from a server using the RPL (Remote
Program Load) scheme, enable this option.
Token-Ring RPL
Only if the computer has a Token-Ring module fitted, with
a remote boot (RPL) ROM installed is this option available.
Under these circumstances, if the computer is connected
to a Token-Ring network, and it is to boot remotely, enable
this option.
Other
This option is provided for possible future implementation
of other remote boot methods. It is currently greyed out.
Disk Types
Hard disk
The hard disk type is detected automatically. This text box
is used to display the type of hard disk installed, if any.
Floppy disk
The LS Pro can be fitted with a 1.44 Mbyte 3.5 inch floppy
drive. If a drive is fitted it is detected automatically. This
text box is used to display whether a floppy is fitted or not.
11