Troubleshooting - Panasonic EW1611 Operating Instructions Manual

When the identification ring is coming
off, as shown in the right figure, align
the nozzle with any direction of the
identification ring to install it
• Even if the identification ring is
not attached, it does not affect the
performance of the nozzle.

Troubleshooting

Problem Possible cause
The nozzle is
No water comes
clogged.
out, or water jet
The outlet of nozzle
power down.
is squashed.
The nozzle
The nozzle is
comes off during
deformed.
use.
The power plug is
Fail to pulled out from the
remember the household outlet
water pressure before the power
level. switch " " is
turned off.
Motor sound
changes after
This is not an abnormality. Please use the
the Stop/Jet
product as usual.
switch is set to
" " (Stop).
12
PB014814 - EW1611W551 _(01EN)_05-11-17.indd 12
Problem
The power
is cut off
automatically.
Action
The water
pressure level
LED indicator
still flashes after
the power switch
Replace the
" " is turned off.
nozzle.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service center authorized by
Panasonic for repair.
Before pulling
out the power
plug from the
household outlet,
turn off the power
switch " ".
Possible cause Action
The function for
This is not an
avoiding forgetting
abnormality.
to turn off is
(See page 9.)
activated.
The self-protection
function is Turn on the power
activated due to a switch " " again.
thunderstorm etc.
This is not an abnormality.
The indicator will be off after 1 minute of
turning off. (See page 10.)
2017/5/11 16:04:26