After Use - Panasonic EW1611 Operating Instructions Manual

After use

1. Open the water tank cap,
remove the water tank, and
throw away the remaining water.
• While removing the water tank, press
the main unit by hand.
• Change the water every time you use
the irrigator.
• Remove the dirt inside the water tank
with a sponge brush etc.
• The water tank can be washed in
a dish washer.
• The water tank cap cannot be
cleaned in a dish washer.
2. Install the water tank, and turn
on the power switch " ".
3. With the nozzle facing the basin,
set the Stop/Jet switch to "
(Jet mode) to remove the
remaining water from the main
unit.
4. When there is no water coming out, set the Stop/
Jet switch to " " (Stop), and turn off the power
switch " ".
5. Disconnect the power plug from the household
outlet.
PB014814 - EW1611W551 _(01EN)_05-11-17.indd 11
6. Push the release button on
7. Clean the handle, and put it
When cleaning the nozzle and handle
• Do not use lukewarm water exceeding 50 °C (122 °F).
• Use neutral kitchen detergent and rinse well with water to
• Wipe away the water with a towel or the like, keep the
• The nozzle cannot be cleaned in a dish washer.
Stop/Jet switch
When wiping stains away from the
"
main unit with a cloth that has been
soaked in soap water and then wrung
out
• Never use thinners, benzine, or alcohol.
• Do not wash the main unit with water.
• Use cotton swabs to clean any part that
the body to release the nozzle,
then wash it. Keep the nozzle.
• The nozzle stand cannot be
cleaned in a dish washer.
back into the main unit.
ensure no detergent remains after cleaning.
product in the dry place.
(Doing so may cause malfunction,
cracking or discoloration of the parts.)
is inaccessible to the cloth.
Nozzle
release
button
11
2017/5/11 16:04:25