Fitting The Backing Pad And Sanding; Fitting The Wire Brush; Fitting The Cup-Grinding Wheel With Wheel Guard - Metabo W 7-100 Instructions For Use Manual

02 ENG_Paddle_8390_0207
13.3

Fitting the backing pad and sanding

disc
Use only the clamping nut supplied
along with the backing pad.
Locate the backing pad (i) on the spindle, as
illustrated. Mount the sanding disc (k) with the
backing pad clamping nut supplied. Lock the
spindle in position. Tighten the sanding disc and
backing pad by turning clockwise by hand.
Slacken off manually or with the pin spanner (13),
as necessary.
13.4

Fitting the wire brush

Fit the hand guard.
Remove the wheel guard (4). Lock the spindle in
position. Mount the wire brush (f) and tighten with
the 22 mm AF open-ended spanner (7/8").
08.11.2007 15:40 Uhr
13.5
Remove the wheel guard (4). Fit the cup-grinding
wheel guard to the angle grinder, turning it on in
the direction indicated by the arrow until fully in
position. Use a screwdriver to tighten the screw.
Locate the inner flange (10) on the spindle,
ensuring that the flange cannot turn on the
spindle. Position the cup-grinding wheel so that it
rests evenly on the inner flange.
Screw the clamping nut (12) or the Quick
clamping nut (11) onto the spindle. Lock the
spindle in position. Secure the cup-grinding wheel
with the clamping nut (12) or the Quick clamping
nut (11).
Use the offset pin spanner (n) if the clamping nut
(12) is being used.
Set the cup-grinding wheel/wheel guard projec-
tion as required (approx. 0.5 - 1 cm/0.2" - 0.4").
Seite 19
ENGLISH
Fitting the cup-grinding wheel
with wheel guard
10
19